Water-Damaged Phone: What to Do First

The first ten minutes after a phone gets wet, in order, and the common advice that makes things worse.

Key takeaways

  • Take it out of the liquid, switch it off and do not charge it.
  • Rinse off salt water or sugary drinks with a little clean water before drying.
  • Use the speaker tone only once the phone is working normally and only the sound is muffled.

Try the tool. Speaker muffled after getting wet? Play the water eject tone now.

Open the water eject tool

The first ten minutes

What you do straight away matters more than anything you do later. Work through this in order.

  1. Get it out of the liquid and unplug any cable.
  2. Switch it off if it was in anything other than a light splash. A phone that is off cannot short-circuit across wet contacts.
  3. Remove the case and the SIM tray. Water hides behind both.
  4. Wipe it down with a soft cloth, including the ports and the camera surround.
  5. Tap out the ports. Hold the phone with the charging port down and tap it gently against your palm.
  6. Leave it in moving air. A shelf near a fan is ideal. Warm, dry and breezy beats hot.

It depends what the liquid was

Clean tap water is the best case. It dries without leaving much behind.

Sea water, pool water, soft drinks, beer and soapy water are different. As they dry they leave salt, sugar or residue on metal contacts, and that residue keeps corroding after the phone looks dry. If your phone is rated as water resistant, rinse the affected area briefly with a small amount of clean water before drying it. It feels wrong, but it removes what would otherwise stay inside.

Advice to ignore

  • A bag of rice. It does not pull water out of a sealed phone, and dust and starch from the rice can end up in the ports.
  • A hair dryer, oven or radiator. Heat softens the adhesive that keeps the phone sealed and can damage the battery.
  • Shaking it hard. That spreads water to places it had not reached.
  • Charging it to see if it works. Power across wet contacts is how a wet phone becomes a dead one.

Where the speaker tone fits

A low tone played through the speaker clears water from the speaker chamber and nothing else. That makes it the right tool for one specific situation: the phone works normally, but sound is quiet or muffled.

Once the phone has been wiped down and is behaving, run the water eject tool with the volume up, the case off and the speaker pointed down. Two or three cycles are enough. The guide to how the water eject sound works explains what is happening and why more is not better.

If the phone was fully submerged or was in salt water, deal with drying first and the speaker second.

Signs it needs a repair shop

Take it in rather than waiting if you notice any of these:

  • The phone gets warm while switched off or idle.
  • The screen shows lines, patches or flickers.
  • It will not charge the next day, or shows a liquid warning that does not clear.
  • There is fog or droplets under the camera lens.
  • One speaker is still silent after a full day of drying.

A shop can open the phone, clean the board with isopropyl alcohol and replace a speaker module, which is usually a quick and inexpensive part.

Checking the speakers afterwards

When the phone is dry and working, compare both speakers with a left and right sound test. If one is weaker, the checklist for fixing a phone speaker will tell you whether it is water, dirt or a setting.