How to Clean Phone Speakers Without Damage
A safe cleaning routine for speaker grilles using a dry brush, putty and a tone, plus the tools to keep away from the mesh.
Key takeaways
- Most quiet speakers are dirty, not broken. Lint and skin oils block the mesh over time.
- Work dry first: a soft brush, then cleaning putty, then a tone to shake out what is loose.
- Never push pins, cotton buds or compressed air into the grille.
Try the tool. Speaker muffled after getting wet? Play the water eject tone now.
Open the water eject toolWhy speakers get quieter over time
Behind the grille you can see is a very fine mesh. Its job is to keep dust and water away from the diaphragm, and it does that job by collecting everything itself. Pocket lint, skin oils, make-up and dried splashes build up slowly until less sound gets through. Because it happens over months, most people do not notice until calls become hard to hear.
The good news is that a blocked mesh is a cleaning problem rather than a fault, and cleaning it takes about five minutes.
What you need
- A soft, dry, clean toothbrush or a small anti-static brush
- Cleaning putty or a small piece of low-tack adhesive putty
- A microfibre cloth
- A bright light, and a magnifier if you have one
You do not need liquid for a routine clean.
The cleaning routine
1. Look first
Switch the phone off, take the case off and shine a light across the grille at a low angle. You are looking for grey fluff in the holes or a shiny film across them.
2. Brush dry
Hold the phone with the speaker facing down so that loosened dirt falls out rather than in. Brush lightly across the grille in one direction, then at right angles. Light, repeated strokes work better than pressure.
3. Lift with putty
Press a small piece of putty onto the grille, hold it for a second and pull it straight off. Do not push it into the holes. Repeat with a fresh surface until nothing more comes away. Putty is good at lifting the oily film that a brush only spreads around.
4. Shake out what is loose
Switch the phone on, turn the volume up, point the speaker down and run the Clear dust mode in the water eject tool. The vibration knocks out particles the brush loosened but did not remove. The guide to speaker cleaner noise explains what the sound can and cannot do.
5. Wipe and test
Wipe the grille with the cloth and play some speech. Compare both speakers with a stereo sound test.
The earpiece is the dirtiest part
The earpiece slot presses against your face on every call and collects skin oil and make-up. It is also the narrowest grille on the phone. Give it the same routine, with extra care not to press hard, because the mesh sits very close to the surface. If calls are the only thing that sounds quiet, read the guide to fixing a quiet ear speaker.
What to keep away from the grille
- Pins, needles and toothpicks. They puncture the mesh, and a punctured mesh lets dirt reach the diaphragm.
- Compressed air. It can drive debris inward and tear the mesh.
- Cotton buds. They leave fibres behind and push dirt deeper.
- Liquids poured or sprayed on. If you must use isopropyl alcohol on sticky residue, dampen the brush bristles slightly, never the phone.
- Vacuum cleaners. Too much suction for a part this delicate.
How often to clean
Every month or two is enough for most people, and more often if the phone lives in a pocket or you work somewhere dusty. A case with a raised lip around the speaker cut-out catches more lint than it prevents, so brush the case as well.
Earbuds need a gentler version
Earbud mesh is finer and easier to damage than a phone’s. Use the separate guide to cleaning AirPods and earbud speaker mesh.
If cleaning does not help
If the speaker is still quiet after a proper clean, the cause is elsewhere. Work through the checklist for fixing a phone speaker.